![]() SWIM cable for connection to the application via a pin header or a 2.54 mm pitch connector.SWIM cable for connection to the application via an ERNI standard vertical connector (ref: 284697 or 214017) or horizontal connector (ref: 214012).SWIM programming speed rate: 9.7 Kbytes/s in low speed and 12.8 Kbytes/s in high speed.SWIM low-speed and high-speed modes supported.1.65 V to 5.5 V application voltage supported on SWIM interface.USB 2.0 full speed compatible interface.STM32 applications use the USB full speed interface to communicate with Atollic, IAR, Keil or TASKING integrated development environments. STM8 applications use the USB full speed interface to communicate with STMicroelectronic’s ST Visual Develop (STVD) or ST Visual Program (STVP) software. ![]() The single wire interface module (SWIM) and JTAG/serial wire debugging (SWD) interfaces are used to communicate with any STM8 or STM32 microcontroller located on an application board. The ST-LINK/V2 is an in-circuit debugger and programmer for the STM8 and STM32 microcontroller families. ST-LINK/V2 ST-LINK/V2 in-circuit debugger/programmer for STM8 and STM32 ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |